Grating, h 30mm 19x19, 3660 x 1000mm
Type: Cast molded grating. ( TWS = GRP = FRP = GFK )
Material: Isophtalic resin reinforced with fiberglass rovings
Color: Similar to the one specified in the RAL palette
Chemical Resistance: - According to the Merim chemical resistance chart
- Chemical resistance depends on the type of resin used
Tolerances: - Length and width: +2 / -4 mm
- Height: +2 / -2 mm
- Weight: 19 kg/m2 +/- 10%
- Warping: < 10 mm / mb
Structure: - Mold - high quality Isophtalic resin
- Surface - Concave
- Resin content: - about 60%
- Glass content: - about 40%
Fire Resistance: - Self-extinguishing according to DIN EN 13501-1
- Classification in accordance with EN 13501-1 level Bfl-S1
Anti Slip: - Class: 30,5 ° - R 12 according to BRG 181 and DIN 51130
Other: - Standard operating temperature range: - 40 C / + 80 C
- Maximum operating temperature range: - 100 C / + 155 C
- resistance to UV radiation
- Good electrical insulator - does not conduct electricity
- Good thermal insulator - does not conduct heat
Technical Data Sheet
IFR - Isophtalic Fire Resistant
IFR 30/19x19/7x5 - Concave
In accordance with the standards: EN ISO 14122-2: 2016 and DIN 24537-3, the following is adopted:
The minimum loads to be considered for walkways and working platforms are as follows:
- 2.0 kN / m2 with a uniform load on the structure;
- 1.5 kN with a concentrated load applied in the most unfavorable place
on a floor area of 200 mm x 200 mm.
The deflection of the floor surface after applying the load assumed in the design should not be greater than
1/200 of the span of the supports.
The difference in height between the loaded floor surface and the adjacent unloaded floor surface should not
exceed 4 mm.
If the deflection is 1/200> 4mm, it is recommended to use a connector.
According to BGI / GUV-I 588-1, the minimum support of the grating should be equal to the height of the grating,
but not less than 30 mm